 |
 |
|
|
|
|
The Hubs are Fiero front Hubs with the disks machined off. These
modified Hubs will increase the track width of the Fiero by 5/16"
per side. The modified Hubs are required on the front only. The 1988 Fiero do not require these hubs. |
|||
|
The Rotors are used on the Chevrolet Corvette C4. They are re-drilled to the Fiero 5 / 100 bolt pattern. |
||||
|
Front Caliper is a aluminum, dual piston, from a C4 Corvette. The rear Caliper as a aluminum, single piston, from a C4 Corvette. The Emergency Brake is still used on this system without modification of the cable. |
||||
|
These specially designed mounting brackets adapt the Corvette
Anchor Plates to the Fiero Spindles. |
||||
|
Concentricity
Rings are specially designed to keep the Rotors running concentric with the Hubs. Although mounting hardware is not shown in this picture, it is included with the Brake Kit. |
|
Corvette Brakes installed. |
 |
|
Front Rotor is a Chevrolet Corvette C4, 12" vented rotor. |
 |
| Rear view of Front Caliper and brake assembly. |
 |
| Rear Rotor is a Chevrolet Corvette C4, 12" vented rotor. |
| BACK |
|
Copyright © 1999-2010 Erv Fleckstein ( West Coast Fiero ). All Rights Reserved. |
