|
|
Coilover kits
|
WCF performance Spring and rear
Coilover kit
(1984 - 1988). |
|
larger view
specifications |
|
The WCF ultra-high performance Spring Kit was
developed for us by a well known race car spring manufacturer for the enthusiast requiring the highest performance from their Fiero.
This Spring Kit was tested and developed on the West Coast Fiero project car
on the race track to establish correct spring rates and drivability under
high performance conditions. This Kit works extremely well for
auto-crossing as well as demanding road driving (no speeding allowed here).
With this kit, the Fiero rides quite firm, but not uncomfortably hard.
The Spring Kit is a requirement for kit cars with extended A-arms or wheel
spacers, where the suspension geometry has been significantly modified,
adding more leverage to the springs.
This kit is available for 1984 - 1988 Fieros.
|
|
| |
Front springs only |
|
$130.00 |
| |
Front and
rear kit |
|
$350.00 |
| West Coast Fiero rear
coil-over kit (1984 -
1988). |
larger view
specifications |
|
For better handing and high performance driving.
Adjust ride-height. Enables raising or lowering your Fiero by up to 2
inches without compromising ride quality.
This Kit is a MUST
when installing wider and taller tires on your Fiero. Large tires can interfere
with the Spring Perch on the shocks.
(With this Kit you can cut part
of Spring Perch off to accommodate larger tires.) Tire sizes such as
245/40/17 and larger may interfere with the Spring Perch.
This kit fits over your stock, replacement type shocks, (Koni, KYB, Monroe, ect.).
Shock absorbers are not included with the kit.
Most other spring kits
available do
not retain the seating at the top of the spring in position when raising the rear of the
car. The West Coast Fiero Kit retains the spring in the upper spring
perch. |
|
| |
Rear coil-over (pair) |
|
$220.00 |
| Hand built racing Koni
Coil-Over Shocks for the Fiero (1984 - 1988). |
|
|
|
Increase handling and performance of
your Fiero with adjustable ride height and adjustable dampening.
These shocks are 2" shorter than the stock Fiero shocks, providing
approximately the same up-wheel travel before hitting bump stop.
This enables you to lower your Fiero approximately 2
inches.
These Shocks are hand built at our facility using the
Yellow high performance Koni McPherson Strut components. These shocks
have higher dampening / compression and rebound than the standard Red Koni
that you can purchase for the Fiero.
These Shocks are a MUST for the very aggressive Fiero enthusiast, especially
when using springs with spring rate greater than 400 pounds per inch. |
|
| |
Koni racing coil-over (pair) |
|
$827.00 |
|
